Tailoring the Mechanical Properties of Fungal Mycelium Mats with Material Extrusion Additive Manufacturing of PHBH and PLA Biopolymers
2024

Improving Fungal Mycelium Mats with 3D Printing

Sample size: 8 publication 10 minutes Evidence: moderate

Author Information

Author(s): Chen Huaiyou, Klemm Sophie, Dönitz Antonia G., Ou Yating, Schmidt Bertram, Fleck Claudia, Simon Ulla, Völlmecke Christina

Primary Institution: Technische Universität Berlin

Hypothesis

Can the mechanical properties of fungal mycelium mats be enhanced using biopolymers through 3D printing?

Conclusion

The study shows that using PLA significantly improves the tensile strength of fungal mycelium mats compared to PHBH.

Supporting Evidence

  • PLA showed a higher tensile strength of approximately 56 MPa compared to PHBH's 13 MPa.
  • The ultimate tensile strength of M-PLA is about 4.8 times higher than that of pure fungal mycelium mats.
  • Young’s modulus of M-PLA exceeds that of pure mycelium by a factor of 30.
  • Roughness measurements indicated that PLA printed mats had significantly higher roughness than PHBH.
  • Mechanical properties were evaluated using uniaxial tensile tests.
  • SEM imaging revealed differences in adhesion between biopolymers and mycelium.
  • High standard deviation in Young’s modulus indicates variability in fungal mycelium cultivation.
  • 3D printing allows for precise control over the deposition of biopolymers.

Takeaway

This study found a way to make mushroom mats stronger by adding special plant-based plastics using 3D printing.

Methodology

The study used material extrusion additive manufacturing to deposit biopolymers on fungal mycelium mats and tested their mechanical properties.

Potential Biases

Potential bias from the uneven thickness of the fungal mats affecting tensile test results.

Limitations

The standard deviation of Young’s moduli was high due to inhomogeneity in fungal mycelium cultivation.

Statistical Information

P-Value

p<0.05

Confidence Interval

95%

Statistical Significance

p<0.05

Digital Object Identifier (DOI)

10.1021/acsomega.4c07661

Want to read the original?

Access the complete publication on the publisher's website

View Original Publication